How do I troubleshoot my VTech baby monitor?

How do I reset my VTech baby monitor?

FRONT

  1. Press and hold for 3 seconds to enter pairing mode.
  2. Press and hold for 20 seconds to reset the camera settings to factory default.

Where is the reset button on my VTech baby monitor?

You can reset the parent unit by pressing the RESET key at the back of the unit. Use a pin and insert it into the hole on the back of the parent unit, and then press the button inside. Go to www.vtechphones.com to register your product for enhanced warranty support and latest VTech product news.

Why is my VTech baby monitor not working?

If either one of your parent units won’t turn on, you may simply have drained or faulty batteries. Plug in the power cable to the parent unit to check if the device will turn on. If your device will only turn on when plugged into the power cable, then you may have to replace the batteries in your device.

How do I fix my VTech baby monitor?

Reboot your router or camera. Unplug your router and camera for approximately 30 seconds and plug back in. Allow a moment for the devices to reconnect and try again.

IT IS INTERESTING:  Can you put calamine lotion on toddlers?

How do I reset my baby monitor?

Press and hold the reset button on the bottom of the Smart Baby Monitor while the power cord is connected. Hold until the green LED on the front of long flashes and turns off.

Why does my Vtech baby monitor screen keep going black?

This is perfectly normal. It may occur either when the camera re-connects to the parent unit after a loss of signal, or the camera power is turned off then on. This is the camera simply re-calibrating it’s connection and streaming to the parent unit.

How do I sync my VTech baby monitor?

To pair new baby unit:

  1. Press when the parent unit is idle.
  2. Press or to highlight (Camera settings), then press .
  3. Press or to highlight (Pair new baby unit), then press .
  4. Press and hold the PAIR key at the bottom of the new baby unit for 5 seconds. When pairing is successful, you will hear a confirmation tone.

How do I reset my VTech baby monitor rm5764?

Reset the baby unit to factory default.

  1. Press and hold PAIR key until you hear a beep sound.
  2. Release the PAIR key, and then press the PAIR key again five times until you hear another beep sound.
  3. The baby unit will sound another beep when the reset completes. Then, the baby unit will reboot.

Why is my VTech baby camera night vision not working?

If your baby monitor night vision is not working, there may be an issue with your battery, power supply, or monitor settings. … See all the VTech, Press the reset button then re-pair the camera and monitor.

IT IS INTERESTING:  What kind of sperm is best for pregnancy?